SAMSUNG CD /

1998 · driver · development · Nintendo Switch · SAMSUNG Electronics

SAMSUNG CD/DVD-ROM Device Driver, Rev M2.40 (C)Copyright SAMSUNG Electronics Co., Ltd. 1998 ( http://www.sec.samsung.co.kr ) Device Name : Number of drives : Invalid /p switch : No drives found, aborting installation Transfer Mode : Programmed I/O PCI Bus Master DMA Model Name : Firmware version : Port= IRQ= Drive ********************************************** * README For SAMSUNG CD-ROM Drives * * May 1996 * ********************************************** (c) Copyright SAMSUNG Electronics , 1996 http://www.sec.samsung.co.kr ==================================== Tips on using MSCDEX.EXE switch ==================================== 1. [ /M:10 ] It is the added switch in AUTOEXEC.BAT when running CDSETUP.EXE. ( Not specified in the user's manual) =========================================== Tips on using SSCDROM.SYS switches ( Not specified in the user's manual) =========================================== 1. [ /P:xxx,yy,z ] Specifies the IDE port that is connected to the drive, and the interrupt request. Where * xxx is the IDE port address xxx = 1f0 : Primary (Channel 1) 170 : Secondary(Channel 2) 1e8 : Channel 3 168 : Channel 4 * yy is the Interrupt channel. yy = 14 : Primary (Channel 1) 15 : Secondary (Channel 2) 11 : Channel 3 10 : Channel 4 * z is the Master/Slave selection. z = 0 : Master 1 : Slave Note: If /p:xxx,yy,zz is valid,the device driver will only test that specific IDE port, and skip the auto-detection. If the /p switch is not used or if any parameter is invalid, the device driver will still use auto-detection algorithm. For example, when the CD-ROM drive is connected to the secondary port using interrupt 15 as slave, the syntax in the CONFIG.SYS file should be as follows: Device = C:\SAMSUNG\SSCDROM.SYS /D:SSCD000 /P:170,15,1 /V 2. [ /V ] Displays CD-ROM Drive Model Name and Firmware Version.